Hi everyone,
I wasn't sure if I should make a new thread or not, so sorry if I shouldn't have.
Either way, I just soldered my voltage line inducer for DreamPi. I followed this thread and thested everything with my multimeter but some doubts occur to me that made me fear to test it out and fry anything:
In a phone line the cables are reversed, the green and red lines switch from end to end of the cable. So I started with one end having the red cable on the second position and it ends on the third one. I've also noticed that some cables meant only for data aren't reversed. Should I unreverse mine in the circuit or leave them be?
Is the inducer is unidirectional? If so, the left side of the scheme should be connected to the Dreamcast or to the USB modem?
Finally, the USB modems I fine only seem to use the green and red line, is it sufficient?
Thank you.