Page 19 of 40
Re: Adapter for MAPLE (Release)
Posted: Thu Dec 31, 2020 4:04 pm
by RazorX
my rev 2 board is finally setup and working
Video:
https://youtu.be/4ty_4TTFaE0
it's still not super stable even with a short cable but it's not bad at all
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 1:33 pm
by kingzr00
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 1:43 pm
by kingzr00
This may help, this is another person's project, through the ATMEGA168 to achieve controller connection USB, he pointed out that stable data only 240 ns, with 250 samples of data will lose packets!
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 1:53 pm
by s_d_a_i
He is reading the DC controller, not creating a new controller
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 2:56 pm
by RazorX
s_d_a_i wrote:He is reading the DC controller, not creating a new controller
are you also having an issue where it doesn't show up on boot or restart until you reboot the stm32? and is it like that on all the current firmware releases, I've currently got ArcadeStick_test flashed to mine.
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 3:05 pm
by s_d_a_i
Yes, I have the same problem on multiple pills, once the controller is lost it is not reconnecting again via command 1, that's why I've sent the original controller screenshots with the stm32 capture to compare.
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 3:12 pm
by RazorX
s_d_a_i wrote:Yes, I have the same problem on multiple pills, once the controller is lost it is not reconnecting again via command 1, that's why I've sent the original controller screenshots with the stm32 capture to compare.
on my board setup you've seen above what I do is leave it connected to port 4 and boot the DC then goto the memory card screen and press the reset on the pill for a sec and then it usually shows up and tends to work fine after that but if I mess with it too much it can disconnect, also if I am in a game and soft reboot the DC it is not there again.
Re: Adapter for MAPLE (Release)
Posted: Sun Jan 03, 2021 5:04 pm
by megavolt85
this project does not even know half about mapple bus from what I know
after I find time to finish this project, I will bury the raphnet project
Re: Adapter for MAPLE (Release)
Posted: Mon Jan 04, 2021 3:27 pm
by s_d_a_i
megavolt85 wrote:
this project does not even know half about mapple bus from what I know
after I find time to finish this project, I will bury the raphnet project
Yes, it will be great once the stability is improved.
Re: Adapter for MAPLE (Release)
Posted: Mon Jan 04, 2021 3:55 pm
by megavolt85
s_d_a_i wrote:Yes, it will be great once the stability is improved.
I wanted the data to be read faster from the virtual VMU, but it turned out that this does not work for everyone.
will have to slow down to the speed of the original controller