USB4MAPLE adapter

[MoeFoh]

New one - 8bitdo Ultimate 2.4g wired d-input.

seems no different from Pro 2, didn’t add new code, just added this PID to Pro 2
test it
usb4maple(22.05.24).7z

Yep, it's a Pro 2 in a different form factor:

2 changes:
Twin Stick mode:
U is D
D is U
on RS
(reversed)

FPS mode:
LB is U
RB is D
(reversed)

Doing both of these on both controllers (makes sense).

Everything else looks great!

[megavolt85]

Yep, it's a Pro 2 in a different form factor:

fixed

usb4maple(22.05.24).7z

(51.75 KiB) Downloaded 141 times

[MoeFoh]

Yep, it's a Pro 2 in a different form factor:

fixed
usb4maple(22.05.24).7z

Buttons all good.

No vibration ability detected. 240p TS doesn't show a JumpPack like it should.

[megavolt85]

No vibration ability detected. 240p TS doesn't show a JumpPack like it should.

alas, I have no information on how this controller turns on vibration

[MoeFoh]

No vibration ability detected. 240p TS doesn't show a JumpPack like it should.

alas, I have no information on how this controller turns on vibration

Looks like 8bitdo doesn't support vibration in ANY of its controllers (that have motors) in d-input mode , only x-input & Switch modes. Checked with gamepad-tester.com and the vibration field is greyed-out when the controller is in d-input mode.

[megavolt85]

PS5 Dualsense now supported, vibration too

usb4maple(24.05.24).7z

(52.3 KiB) Downloaded 153 times

[BaronBurdock]

Has anyone made an adapter that involved soldering a female USB to the test pads of a regular pi pico? I made two that way, but its behaving weirdly when I plug a 360 controller in.

I tried playing Quake 3 with the all analog mode enabled and every time I pulled the right trigger it disconnected and went back to whatever the top left mode is on the xbox 360 button. Sometimes it would get stuck turning.

In Tony Hawk, it kept saying it was disconnected and reconnected. I figured it was bad soldering at first, but both cables are behaving this way and I tested to make sure something wasnt shorting out. Really weird

[megavolt85]

your problem is more like a bad power supply, when vibration is turned on, the voltage drops significantly and the controller turns off

[BaronBurdock]

Yup, thats exactly it. I tested it with 3rd Strike, as soon as I turned the vibrate on in the menus the controller reset. I'll look into that. Thanks

[rpf16rj]

My custom enclosure is now available for download from Printables! https://www.printables.com/model/840316 ... e-by-megav

There's no logo on the model itself. It's just in the picture.
adapter.png

Hey @pcwzrd13, I began on a 3d printer and used your model, thank you for a great job, it is amazing.







Could you create the model 3d for rp2040 pico, if don't ask much? This one: