Modem showing 0 lights?

[VKNIGHT20]

I'm receiving an issue after trying to fix my dreampi. After installing the newest version of dreampi onto my microsd card (After wiping it beforehand of course) I now get 0 lights on my modem once the pi is plugged into the wall. As well, once hooked up to HDMI into my television, it receives no response. I checked on the pi itself, and it shows a red light indicating that it is receiving power. Everything is successfully plugged in. Any clue as to what could be happening?

[pcwzrd13]

Sounds like the image didn't write to the SD card correctly. The Pi isn't detecting anything to boot from.

[VKNIGHT20]

I tried that to be sure. Followed this (https://www.youtube.com/watch?v=VgRLnj2YR3s) guide, and tried to write the image on two separate micro SD cards. I put one in and it flashed both lights for around a millisecond before going blank. Even redownloaded the image to try it a second time. It shows it as two sd cards once put into my pc (Boot and SDHC). Which one should I put the image onto?

[pcwzrd13]

Does the green light on the Pi itself flash when you power it on? That would tell you if it's booting or not. If you just get a red power light with no green light then it's not booting.

As for writing to the SD card, you can just overwrite the drive labeled "boot".

[VKNIGHT20]

Got it back online finally. Just had to download an sd card formatter, and was able to reapply the Dreampi image.