Any recommendations/tips/videos for soldering? I've watched a few videos but can never seem to solder properly - always seem to heat up far too much solder.
Looking to desolder the CMOS battery in my DC
Re: Soldering
Posted: Sat Dec 07, 2024 5:22 pm
by OatBob
It's OK if de-soldering is a bit hotter, maybe even easier. You will need to partner up with a wick or pump to remove the liquid metal.
I personally use a wick. It's pretty simple. Mash the hot iron on the braided copper, and watch it soak up the solder.
The controller board mods are a great beginner project. CMOS battery, controller fuse, and LED. When you are successful, hopefully it will give you more confidence for future projects.
Re: Soldering
Posted: Sat Dec 07, 2024 5:31 pm
by OatBob
You can see a de-soldering pump in action here:
Skip to 2:27