GDEMU Compatibility
Posted: Mon Apr 07, 2025 1:09 pm
I found a few threads that easily stated the console needed to ensure compatibility with a GDEMU.
My question here is regarding two specific components (one of which I've never seen before).
The console I have has the 1 designation with a circle around it shown on the underside label. Granted these consoles are old, I assumed I purchased an unmodified console.
When I opened it up, the controller port board has a 3 within the circle whereas other threads show a 1.
There is also a an odd number of wires protruding from underneath the metal plate (that sits under the disc reader assembly) and it is connected to a small PCB wrapped in heatshrink.
Is this component sticking out normal, and does the 3 on the controller board warrant a red flag?
My question here is regarding two specific components (one of which I've never seen before).
The console I have has the 1 designation with a circle around it shown on the underside label. Granted these consoles are old, I assumed I purchased an unmodified console.
When I opened it up, the controller port board has a 3 within the circle whereas other threads show a 1.
There is also a an odd number of wires protruding from underneath the metal plate (that sits under the disc reader assembly) and it is connected to a small PCB wrapped in heatshrink.
Is this component sticking out normal, and does the 3 on the controller board warrant a red flag?