dcdigital hw2

[truemaster1]

hello i have decited to install the dcdigital hw2 and put akura hdmi to rest and i have an issue. if i select force vga instead of cable select in the video settings the console will not output any image. if i select cable select is fine. i have updated to latest firmware, and the check status shows all hearts whitch means all solder points are fine. the work around on this issue is to plug akura in this case the dcdigital will produce screen with force vga enable just fine. it looks like the dcdigital cant force vga by it self. has anyone solution to this issue?

[ateam]

Just chiming in to say that yes, DCDigital HW2 does "Force VGA" the same way as HW1.

I don't have the expertise to help troubleshoot your issue. You should drop by the PixelFX Discord for support. You'll have the most success that way.

https://discord.gg/pixelfx

[truemaster1]

ok thanks i will do that